How to Install Tape On Window Visors on a Chevy Silverado

By Armordillo® | Premium Truck & SUV Accessories – Armordillo4x4 | Published: 2026-10-25

Category: How-to Guides

Learn how to install tape-on window visors on your Chevy Silverado 1500 Extended Cab with this step-by-step guide. Includes prep tips and common mistakes to avoid.

Quick answer

Installing tape-on window visors on a Chevy Silverado 1500 Extended Cab takes about 30 minutes and requires only basic cleaning supplies. The key is proper surface prep and alignment before pressing the adhesive strip into place.

Why tape-on visors for your Silverado?

Tape-on window visors offer a clean, low-profile look without drilling into your truck's door frame. They let you crack the windows for fresh air while keeping rain and wind out, which is especially useful during unpredictable weather or when parked with the windows slightly open.

The main trade-off is that the adhesive bond depends entirely on surface cleanliness and temperature. If you rush the prep or install in cold conditions, the visors may not stick as well over time.

Step-by-step installation

1. Clean the door frame surface: Wash the top edge of each door frame with soap and water, then wipe with isopropyl alcohol to remove all wax, grease, and dirt. Let it dry completely. Common mistake: Skipping the alcohol wipe leaves residue that weakens adhesion.
2. Dry-fit the visor without removing the tape liner: Hold the visor against the door frame to check the fit and alignment. Mark the position lightly with painter's tape if needed. Checkpoint: Make sure the visor sits flush along the entire edge before committing to the adhesive.
3. Warm the visor and the door frame (if below 70°F): Use a hair dryer or heat gun on low to warm both the adhesive strip and the painted surface. This improves initial tack and long-term bond strength. Common mistake: Cold surfaces cause the tape to fail within weeks.
4. Remove the liner and press the visor into place: Peel the protective backing from the adhesive strip. Starting at one end, press the visor firmly onto the door frame, working toward the other end. Apply even pressure for 30–60 seconds. Checkpoint: Use your palm, not fingertips, to avoid uneven pressure that creates gaps.
5. Let the adhesive cure for 24 hours: Keep the windows closed and avoid car washes or heavy rain for at least 24 hours. The adhesive reaches full strength after a full day. Common mistake: Washing the truck too soon can lift the visor edges.

Product used in this guide

ARMORDILLO® 1999-2006 Chevrolet Silverado 1500 Extended Cab Tape On Window Visors: These tape-on side window visor deflectors are designed to let fresh air into your vehicle while helping keep rain, wind, and drafts out. They fit the 1999-2006 Chevy Silverado 1500 Extended Cab and include a premium adhesive strip for a no-drill installation that stays secure when properly applied.
ARMORDILLO® 1999-2006 Chevrolet Silverado 1500 Extended Cab Tape On Window Visors