Tape-On Window Visors: Installation and Fitment Guide
By Armordillo® | Premium Truck & SUV Accessories – Armordillo4x4 | Published: 2026-10-29
Category: How-to Guides
Learn how to install tape-on window visors on your Chevy Silverado or Dodge Ram. Step-by-step guide with fitment tips for a clean, no-drill upgrade.
Quick answer
Installing tape-on window visors is a straightforward, no-drill process that takes about 30 minutes. The key is proper surface cleaning and alignment before pressing the adhesive strip into place.
Why tape-on visors are a smart upgrade
Tape-on window visors let you enjoy fresh air without letting rain, wind, or drafts inside. They also reduce wind noise and help remove stale odors from the cab. Because they attach with adhesive rather than screws, you avoid drilling holes in your truck's bodywork.
The main trade-off is that the adhesive bond is permanent once fully set. You cannot reposition the visor after the tape has bonded for more than a few minutes, so careful alignment is critical.
Fitment considerations for Chevy Silverado and Dodge Ram
These visors are designed for specific model years and cab styles. The ARMORDILLO tape-on visors for the 2007-2013 Chevy Silverado 1500 Extended Cab and the 2009-2018 Dodge Ram 1500 Crew Cab are shaped to match the window contours of those vehicles. Using them on a different cab style may result in poor adhesion or improper sealing.
If your truck has aftermarket window tint or a textured surface, the adhesive may not stick as well. Clean the glass thoroughly and consider a primer if the surface is non-porous.
Installation steps
- Clean the window surface: Wash the glass with isopropyl alcohol or a mild degreaser to remove dirt, wax, and oil. Dry it completely with a lint-free cloth. Any residue will weaken the adhesive bond. If the glass feels tacky after cleaning, repeat the step.
- Dry-fit the visor: Hold the visor against the window in its intended position. Mark the top edge lightly with removable tape or a grease pencil so you know exactly where to place it. Once the adhesive backing is peeled, you have about 30 seconds to adjust. Skipping the dry-fit often leads to crooked placement.
- Peel and apply the adhesive strip: Remove the backing from the included adhesive strip and press it firmly onto the visor's mounting surface. Then peel the other side and align the visor with your marks. Press evenly across the entire strip for 30 seconds. Apply pressure from the center outward to avoid air bubbles. Do not test the bond by pulling on the visor for at least 24 hours.
- Let the bond cure: Leave the visor undisturbed for 24 hours in moderate temperatures (60–90°F). Avoid car washes or heavy rain during this period. Heat or cold extremes can weaken the cure. If temperatures are below 50°F, warm the glass with a hair dryer before applying.
Products used in this guide
- ARMORDILLO® 2009-2018 Dodge Ram 1500 Crew Cab Tape On Window Visors: Designed for 2009-2018 Dodge Ram 1500 Crew Cab; tape-on installation with included premium adhesive strip. No drilling required, and the adhesive strip provides a clean exterior look while keeping rain and wind out.
ARMORDILLO® 2009-2018 Dodge Ram 1500 Crew Cab Tape On Window Visors - ARMORDILLO® 2007-2013 Chevrolet Silverado 1500 Extended Cab Tape On Window Visors: Designed for 2007-2013 Chevy Silverado 1500 Extended Cab; tape-on installation with included premium adhesive strip. Matches the specific window shape of the Silverado Extended Cab, ensuring a snug fit and reduced wind noise.
ARMORDILLO® 2007-2013 Chevrolet Silverado 1500 Extended Cab Tape On Window Visors
