Tape-On Window Visors: How to Install on a GMC Sierra 1500
By Armordillo® | Premium Truck & SUV Accessories – Armordillo4x4 | Published: 2026-11-03
Category: 사용 방법 가이드
A step-by-step tape-on window visor install for the 2007–2013 GMC Sierra 1500 Extended Cab, with prep, adhesive tips, and fitment checkpoints to avoid common mistakes.
Quick answer
Install tape-on window visors on a 2007–2013 GMC Sierra 1500 Extended Cab by cleaning the door frame, test-fitting each visor, applying the included adhesive promoter if supplied, and pressing the visor firmly for 60 seconds. Work in warm, dry conditions and avoid rolling down the windows for 24 hours.
Why prep and temperature decide whether the tape holds
Tape-on visors rely entirely on the adhesive strip, so surface prep is the installation. Dust, wax, and silicone dressings prevent the tape from bonding; wipe the door frame with isopropyl alcohol and let it flash off completely. Cold weather makes the tape stiff and less tacky—if the ambient temperature is below about 60°F (15°C), warm the frame and the adhesive with a hair dryer on low before pressing.
The 2007–2013 Sierra 1500 Extended Cab has rear doors that open independently, so each visor sits on a separate frame. Test-fit all four pieces before peeling any backing; if a visor does not sit flush, stop and check that you have the extended-cab set rather than a crew-cab set.
Drilling vs. tape: the trade-off for this truck
Tape-on visors need no drilling, which preserves the door frame and keeps the install reversible. The trade-off is that tape-on visors depend on clean adhesion and are easier to snag in automatic car washes. If you frequently run through brush-style washes, hand-wash the upper door frame or choose a drilled style instead. For most Sierra 1500 Extended Cab owners, tape-on is the simpler, lower-risk route.
Step-by-step tape-on visor installation
- Wash and degrease the door frame: Wash the truck, then wipe the upper door frame where the visor sits with isopropyl alcohol on a clean microfiber cloth. Let it dry fully. Do not skip the alcohol wipe; soap and water alone leave a residue that shortens tape life.
- Test-fit all four visors: Hold each visor against its window frame without removing the backing. Confirm the front and rear pieces match the extended-cab door shape and sit flush. If any piece is misaligned, stop—do not peel backing to force a fit.
- Warm the frame and tape: In cool weather, warm the door frame and the adhesive strip with a hair dryer on low for 30–60 seconds. Keep the gun moving and do not overheat the plastic. Aim for a warm, dry day above 60°F (15°C) if you can.
- Peel and position the visor: Peel 2–3 inches of backing from each end, align the visor to the frame, and press the exposed ends first. Then peel the remaining backing and press along the full length. Keep the visor slightly away from the window glass edge so it does not rub when the window moves.
- Press firmly and cure: Press along the tape line with steady hand pressure for 60 seconds per visor. Do not roll down the windows or wash the truck for 24 hours. Recheck each visor after 24 hours and press again if any edge lifts.
Product facts
- ARMORDILLO® 2007-2013 GMC Sierra 1500 Extended Cab Tape On Window Visors: Tape-on side window visor deflectors with an included premium adhesive strip and no drilling required. The included strip means you do not need to source separate tape, and the no-drill design keeps the door frame intact if you ever remove the visors.
ARMORDILLO® 2007-2013 GMC Sierra 1500 Extended Cab Tape On Window Visors
